Assembly and Installation Instructions
1.Run the plug end of the pump cord through the hole in the back of the fountain bowl. Position the pump in the very bottom of the fountain bowl. Attach the plastic tubing to the output nozzle of the pump and to the copper tubing extending into the back near the bottom of the bowl. You will need to adjust the length of the tubing to give the best performance (do not allow the tubing to crimp as it will cut off the flow of water).
2. Locate and install mounting bracket on wall with 3/4 inch angle pointing up.
3. The inverted groove in the back of the fountain slips over the mounting bracket.
4. After the fountain has been hung, add water to the bowl up to the level of the hole in the back of bowl where electrical cord comes through. Plug in the pump. The pump has three settings I, II and II with I being the lowest. We suggest you start with setting I.